How to ENABLE snmp

[docsis_bozo]

If you mean you do this on the remote modem so that it can be accessed on your local box, then there are possibly better ways to go about that. For example by spoofing the user access list and manually setting r/w on the target device. Of course none of this will really work here, my ISP for sure is a step ahead and more secured than most ISP's including your UK carrier.

I challenge anyone that thinks they can just easily bypass the ACL on my ISP.

By the way, Nobody is talking about not being able to access SNMP on their OWN device. Not sure if you are attempting to troll or what?

CM/SNMP> tlv_55 1


WARNING: This will be applied to all 3 registered instances!
Do you really want to do this? (yes|no) [no] yes

Instance: BcmSnmpAgent for IF 1, name = 'Vendor CM Agent w/ BRCM Factory Support' (0x83da21d0)

CPE Management Enabled: 1

Instance: BcmSnmpAgent for IF 6, name = 'emta factory agent' (0x8278a004)

WARNING - unknown command id (458)! Ignoring...

Instance: BcmSnmpAgent for IF 2, name = 'Vendor CPE Agent w/ BRCM Factory Support' (0x82a7152c)

WARNING - unknown command id (458)! Ignoring...


Boohoo?
Why not just set FM on Web IF or set cdPrivateMibEnable.0 int 2/allow_config true, much easier and this way at least I know for sure I have full temp SNMP access on my own devices.