22-12-2008, 06:00 AM
(06-12-2008, 04:13 PM)alan Wrote: Would anyone happen to no the addresses to image1 ect,ect in a 2Mb Sb5102 dump so i can rip it open in hex editor.
I dont have the actual modem i just have the 2Mb dump but i want to try and extract the firmware from it to try on another project and ime not sure if there the same as the Ambit250/255/256 IE:
0x000000 = BOOTLOADER
0x008000 = PERMANENT
0x010000 = FIRMWARE 1
0x100000 = FIRMWARE 2
0x1F0000 = DYNAMIC
Also the modem i want to try it on hasent got jtag points so ime guna have to whip the tsop of and program it with programmer henze me asking as i want to try and get it right first time
5102 is spi not tsop based.... it has drect spi access on the multipin hader, just look on the sb5102 usbjtagnt page at usbjtag.com...
also the 5102 has a mains voltage psu in board so be be careful messing around on the pcb...