13-03-2015, 02:07 AM
DHCPForce is really simple to use, even if your modem is in walledgarden will no outside ip...
Open the program and your firewall should start screaming that it wants access..allow dhcpforce in your firewall for full access.
open the first dropmenu labelled DHCP and click on start sniffing.
In a few seconds you should see a few configs in the bottom of the program where it says count. You need to let it run for a few days to get the entire node.(IF THE COUNT STAYS AT 0 SOMETHING IS BLOCKING THE PROGRAM...figure out what is, and then start over!)
Every few hours or so, you should right click in the box that shows cfgs and select "remove duplicate macs" and then click on dump info to file.
this file will contain your macs/cfg's
Extremely useful program for seeing what your node contains and if it is oversold.
Open the program and your firewall should start screaming that it wants access..allow dhcpforce in your firewall for full access.
open the first dropmenu labelled DHCP and click on start sniffing.
In a few seconds you should see a few configs in the bottom of the program where it says count. You need to let it run for a few days to get the entire node.(IF THE COUNT STAYS AT 0 SOMETHING IS BLOCKING THE PROGRAM...figure out what is, and then start over!)
Every few hours or so, you should right click in the box that shows cfgs and select "remove duplicate macs" and then click on dump info to file.
this file will contain your macs/cfg's
Extremely useful program for seeing what your node contains and if it is oversold.