11-02-2015, 07:35 PM
Come to think of it, I do already have a USB SPI programmer, very similar (same chips) as this one:
http://www.ebay.com/itm/AVR-USB-JTAG-emu...1068485925
It is installed and in device manager it is a
Prolific USB to Serial Comm Port
I installed the avrstudio from Atmel, but it says it's not able to find the board, (I have no flash chip connected to flash at this time).
So what should I do? This parallel flashing post is really great, but I haven't found anything like that to go by with the USB Jtag SPI flasher I have on hand.
http://www.ebay.com/itm/AVR-USB-JTAG-emu...1068485925
It is installed and in device manager it is a
Prolific USB to Serial Comm Port
I installed the avrstudio from Atmel, but it says it's not able to find the board, (I have no flash chip connected to flash at this time).
So what should I do? This parallel flashing post is really great, but I haven't found anything like that to go by with the USB Jtag SPI flasher I have on hand.