30-04-2014, 10:14 PM
(This post was last modified: 01-05-2014, 12:16 AM by franklinzero.)
(29-04-2014, 04:38 PM)KnoxK Wrote: remove all of what you said...... do you still have original back up and firmware for your sb5101? if so restore....let your isp boot right configs through coax.....reflash hax.....have a great time surfing....your mac and certs also must be valid with each other and provisioned on your isp.... your help menu in your original firmware from isp upgrade will indicate your stealth settings for hax...
I did that, now modem dont even boot, and when i try to load anything with ldram or load boot i got an "Address out of range" error and next all comands lead to BUSY!
Like this:
Code:
jtag> detect
JTAG communication failure, check connection, JTAG interface, target power etc.
jtag> detect
Read IDCODE: 0x0334917f
Manufacturer: Broadcom
Part: BCM3349
Version: 0x0
---------------------------------
Create & Clear RAM Buffer (0x80000000 - 0x80800000)
Load Configuration File: bcm3349.def
IR Length: 0x5
Endian: Big
Protocol: EJTAG
RAM Start Address: 0x80000000
RAM Size: 0x800000
FLASH Start Address: 0x9fc00000
---------------------------------
Read IMPCODE: 0xfffffffe
EJTAG Version: Unknown
EJTAG DMA Support: No
---------------------------------
Detect FLASH : Unknown (Manufacturer’s: 0x334917f Device: 0x0000)
jtag> ldram 9fc00000
Address out of range
jtag> detect
BUSY!Any tips to solve it?
Edit: I'm following some unbrick tutorial right now, trying to fix by myself, dont bother with the last question.
Edit 2: Got it! Detected and flashing NOW
Edit 3: Unbriked. \o/