02-01-2014, 10:58 PM
OK guys, I was looking at the 8 pin connector next to the SPI chip on the router and I've done a pinout for it. 2 pins don't appear to go anywhere. Is that correct? Here's what I've come up with, based on http://www.spansion.com/Support/Datashee...64P_00.pdf and my multimeter:
![[Image: EJBNE1p.jpg]](http://i.imgur.com/EJBNE1p.jpg)
It is the connector without any pins soldered to it (yet!)
![[Image: EJBNE1p.jpg]](http://i.imgur.com/EJBNE1p.jpg)
It is the connector without any pins soldered to it (yet!)
![[Image: orO9mDz.jpg]](http://i.imgur.com/orO9mDz.jpg)