31-12-2013, 12:26 PM
(This post was last modified: 31-12-2013, 12:40 PM by teddyalmonds.)
Yes that board will work. The thing is, you'll have to solder wires to the appropriate pads based on the pinout of the AT90USB162 for proper i/o. There may be an issue with the 5v. I saw that some people decided to cut the 5v line on the incoming usb and power the dongle externally to switch between 5v an 3.3.
If it's an adventure that you want to pursue then it's certainly cheap. If you don't want to bother with that shit, I'd say spend the $20 and get a board already done with the 3.3/5v toggle, all the headers already implemented and be done with it.
If it's an adventure that you want to pursue then it's certainly cheap. If you don't want to bother with that shit, I'd say spend the $20 and get a board already done with the 3.3/5v toggle, all the headers already implemented and be done with it.