I have to wonder if a board like this would work with the flashcat/blackcat, http://www.ebay.com/itm/AVR-AT90USB162-U...4177d17cc0
It's an AT90USB162, the flashcat uses an AT90USB162 as described here http://blackcatusbjtag.com/
It seems like all you would have to do is load the .hex files onto the stick and figure out what pins are used on the blackcatusb, im pretty sure they used the following: SCLK= = PB1, MOSI = PB2, MISO = PB3, not sure what they used for CS though...
I think I'm going to order the board I linked and see if I can get it working with the blackcatusb firmware.
It's an AT90USB162, the flashcat uses an AT90USB162 as described here http://blackcatusbjtag.com/
It seems like all you would have to do is load the .hex files onto the stick and figure out what pins are used on the blackcatusb, im pretty sure they used the following: SCLK= = PB1, MOSI = PB2, MISO = PB3, not sure what they used for CS though...
I think I'm going to order the board I linked and see if I can get it working with the blackcatusb firmware.