So. Long story short. I have an hactivated sb5100 from about 5 years ago. Its been a while, 5 years almost since I've touched one and I forgot the procedures, dos commands I used to get it online.I used serial jtag and blackcat software. I recently purchased a refurbished sb5100 in hopes that I could 'clone' the old one and apply that clone to the new modem. Someone on this forum Told me to click the flash tab, select read all, and save image. I applied this image to the new one and when plugged up, lights stay solid for 7 seconds then modem goes completely blank. Jtag utility and blackcat can still detect it so I'm assuming its not totally bricked.
However, I have tried a few firmware for the sb5100, including the stock and they have not revived my modem. at this point, I'm not sure if I should give up on it? Is there something I can try? I don't have any debricking hardware tools or anything, just modem, jtag computer and software.
However, I have tried a few firmware for the sb5100, including the stock and they have not revived my modem. at this point, I'm not sure if I should give up on it? Is there something I can try? I don't have any debricking hardware tools or anything, just modem, jtag computer and software.