27-09-2013, 03:48 AM
(This post was last modified: 27-09-2013, 03:52 AM by southernyankey1970.)
detect
ldram 9fc00000
-select your dump
erase 9fc00000 200000
-it should erase
sprogram 9fc00000 200000
-it should begin to write WITHOUT erasing
If all goes well then type:
cmpram 9fc00000 200000 or click the Verify button
I have never revived a Brick O' Matic cm with the NT w/o using sprogram...it ALWAYS hangs on the erase part when you you use the gui button for write to chip. There is a technical explanation for this at usbjtag.com i just don't remember what it it is and don't need to...use sprogram.
Also remember that your 5100 is older than dirt and the components sometimes just fail. I have 2 in a box that detect but will not program on ANY jtag or serial connection...they are just broken!lol
ldram 9fc00000
-select your dump
erase 9fc00000 200000
-it should erase
sprogram 9fc00000 200000
-it should begin to write WITHOUT erasing
If all goes well then type:
cmpram 9fc00000 200000 or click the Verify button
I have never revived a Brick O' Matic cm with the NT w/o using sprogram...it ALWAYS hangs on the erase part when you you use the gui button for write to chip. There is a technical explanation for this at usbjtag.com i just don't remember what it it is and don't need to...use sprogram.
Also remember that your 5100 is older than dirt and the components sometimes just fail. I have 2 in a box that detect but will not program on ANY jtag or serial connection...they are just broken!lol