24-02-2013, 08:46 PM
(This post was last modified: 24-02-2013, 08:48 PM by modembricker.)
Well, I tried jtagging my DCP3000 modem again to flash fresh firmware because it was failing to lock upstream channel, and while attempting to make contact with the 3v point I brushed my pin across other legs and solder points around the area due to my shaky hands and now I get no lights on the modem and the jtag is not detecting the chip. The modem chips get warm so that tell me there is power going through, but I have no lights. Is all hope lost?