No, nothing to do with a duplicate MAC..Seems to be 1.) T-4 timeouts must be un-checked to ignore. Dont ignore any "T" timeouts
Your were denied the DHCP IP. And were removed from the IP Lease..This was done at the HAL layer..
Something was written, or was tried to be written. Do you have disabled firmware updates? Thats the issue , along with those other 2...Let the CM take the update, then re-flash haxorware..
Below is the Firmware update pending a re-boot, which never is written ..Thus the re-boot cycle as it tries to write and then re-boots, only to be denied
Your were denied the DHCP IP. And were removed from the IP Lease..This was done at the HAL layer..
Something was written, or was tried to be written. Do you have disabled firmware updates? Thats the issue , along with those other 2...Let the CM take the update, then re-flash haxorware..
Below is the Firmware update pending a re-boot, which never is written ..Thus the re-boot cycle as it tries to write and then re-boots, only to be denied
Quote:DefaultSnmpAgentClass::ShutdownPendingEvent for SB5102 CM Agent w/ BRCM Factor
y Support
Quote:CM> Bandwidth request failure! Status = 0
Non-Vol Settings successfully written to the device.
Stopping DHCP/ToD/TFTP (client requested)...
The ToD thread was stopped.
DHCPc: Releasing the lease with client id htype=1, value=00:xx:xx:xx:xx:xx
DHCPc: Sending Release packet; client id htype=1, value=00:xx:xx:xx:xx:xx
0x00011c88 [DHCP Client Thread] BcmEcosIpHalIf::RemoveLeaseImpl: (IP Stack1 Hal
If) Removing lease IP address 10.45.245.154 from IP stack 1
0x00011c88 [DHCP Client Thread] BcmEcosIpHalIf::RemoveLeaseImpl: (IP Stack1 Hal
If) This is the last address on the stack; shutting the stack down:numberOfAddre
sses=1
0x00011c92 [DHCP Client Thread] BcmEcosIpHalIf::ShutdownIpStackImpl: (IP Stack1
HalIf)
Shutting down IP stack 1
Knowledge=Power