SB5101E firmware questions

[Rickz]

i believe this is a bug with haxor.. my isp don't disable telnet. and after registration telnet still is active, so registered with isp or not most commands are not there(directorys like snmp, non-vol and their commands are missing) i even flashed new virgin full flash for chipset intel which has my 5101 and the flashed fresh firm rev 39 diag or lite not matter both has same issue. i'm unable to run commands such as:

--------------------------------
stealth snmp settings
--------------------------------
cd /n/s
max_dload_tries 0
hide_ipstack_ifentries true
docsDevSwAdminStatus 3
docsDevSwOperStatus 2
diag_disable_post_reg true
write

-----------------------------------------
diable external telnet access
-----------------------------------------
cd /n/m
telnet_ipstacks 2
write
--------------------------------
disable ToD time of day requests

cd /non/docsis
enable tod false
write
cd /
reset


Disable SNMP Agent after registration

cd n/s
diag_disable_post_reg true
write

increases detail level of event log.

cd /s
set cmConfigEnableAllEventLogPriorities int 1
(yes)
cd /n
write


prevent US blacklisting at the CMTS

cd /s
set cmConfigT3TimeoutInitRngRetries int 5
(yes)
cd /n
write

(disable remote telnet)
cd non-vol
cd msg-log
telnet_ipstacks 2

(block all remote updates)
cd /
cd non-vol
cd snmp
max_dload_tries 0
write

(hide your ip)
cd non-vol
cd snmp
hide_ipstack_ifentries true
write

Disable SNMP filters (filters that provider sets to restrict ports and IP ranges use):

cd /s
cm_filters off
cd /n
write

Disables reading the modem with snmp commands.

cd /
cd snmp
view_v1v2 Noaccess
y
cd

someone told me to enable factory mode for running those commands.. i actually have it enable from web interface.. still the issue persist..

i flashed Sigma RC1 for 5101(SB5101.SIGMAX2.130.RC1.bin) and i'm able to run all commands...


again i recommend to authors of haxor to check and confirm this issue.

also will be great if certs from SBG901/41 could be used with 5101 :-D

i'm asking too much?

for those who would like to run those commands use a shelled original firmware or the sigma one then reflash haxor on it.. i guess all changes will remain active there ?

maybe not.. if part of non-vol /snmp is erased are we really protected from ISP eyes ? since we can't use stealth options to hide..... this could be serious hole for hac_ked modems

some cuestions to answer... let's give a chance for the experts to respond about this.


My Best Regards