dpc2100 flash with haxorware11rev39-LITE, page not found shows

[tester2]

when i connect hexwre modem, 192.168.100.1, shows below. if this is not, then where i can go to use TELNET command to get Log.....thanks

Task Status
Acquire Downstream Channel In Progress
Obtain Upstream Parameters Waiting
Upstream Ranging Waiting
Establish IP Connectivity Waiting
Retrieve Time of Day Waiting
Negotiate security Waiting
Receive configuration Waiting
Register connection Waiting
Cable modem status Scanning

Event Log
Time Priority Code Description
1970-01-01 00:00:29 Critical T001.0 SYNC Timing Synchronization failure - Failed to acquire QAM/QPSK symbol timing
1970-01-01 00:00:29 Critical T002.0 SYNC Timing Synchronization failure - Failed to acquire FEC framing
1970-01-01 00:00:05 Critical T001.0 SYNC Timing Synchronization failure - Failed to acquire QAM/QPSK symbol timing
1970-01-01 00:00:05 Critical T002.0 SYNC Timing Synchronization failure - Failed to acquire FEC framing
1970-01-01 00:05:05 Critical T001.0 SYNC Timing Synchronization failure - Failed to acquire QAM/QPSK symbol timing
1970-01-01 00:05:04 Critical T002.0 SYNC Timing Synchronization failure - Failed to acquire FEC framing
1970-01-01 00:01:14 Critical T001.0 SYNC Timing Synchronization failure - Failed to acquire QAM/QPSK symbol timing
1970-01-01 00:01:14 Critical T002.0 SYNC Timing Synchronization failure - Failed to acquire FEC framing
1970-01-01 00:00:04 Critical T001.0 SYNC Timing Synchronization failure - Failed to acquire QAM/QPSK symbol timing
1970-01-01 00:00:02 Notice M571.1 Ethernet link up - ready to pass packets
1970-01-01 00:00:02 Notice M571.1 Ethernet link up - ready to pass packets
1970-01-01 00:10:02 Critical T001.0 SYNC Timing Synchronization failure - Failed to acquire QAM/QPSK symbol timing
1970-01-01 00:10:02 Notice M571.1 Ethernet link up - ready to pass packets
1970-01-01 00:10:00 Critical T001.0 SYNC Timing Synchronization failure - Failed to acquire QAM/QPSK symbol timing