Thread Rating:
  • 5 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Arris TG2492 (VM Super hub 3)
#91
You have my interest, just what exactly do you want to modify this firmware to do?
Reply
#92
(14-06-2019, 12:37 AM)neo_ Wrote: You have my interest, just what exactly do you want to modify this firmware to do?

To begin with, standard alpha stuff: ssh, change certs, force config, etc.
Reply
#93
(29-04-2019, 02:20 AM)blacklisted Wrote:
(22-04-2019, 08:08 PM)emantec Wrote: Did you flash my entire dump to your modem? That contained device specific files which may explain your issues.

i have flashed entire dump butr not getting that telnet password.

if there is any update on this would be realy good

Emantec keep us posted with you scripts

you have flash the TG2492  ? through the emmc?
Reply
#94
https://www.youtube.com/watch?v=piILxlabFws
Reply
#95
This is my full story if someone is interrested... https://blog.danman.eu/about-adding-a-st...sis-modem/
Reply
#96
(15-07-2019, 03:14 PM)danman Wrote: This is my full story if someone is interrested... https://blog.danman.eu/about-adding-a-st...sis-modem/

good. ill have to buy an oscilloscope.
Reply
#97
(16-07-2019, 05:04 AM)eltremendo Wrote:
(15-07-2019, 03:14 PM)danman Wrote: This is my full story if someone is interrested... https://blog.danman.eu/about-adding-a-st...sis-modem/

good. ill have to buy an oscilloscope.

If you have the same phison on board, the pinout is the same (this has been verified with several noards). But you can also use logic analyzer, they are cheaper...
Reply
#98
it is yes can confirm.



trhanks once again
Reply
#99
thanks for the great info, going to grab a new modem to test test test
Reply
few people in uk should be able have access to these arris modems
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)