14-06-2019, 12:37 AM
You have my interest, just what exactly do you want to modify this firmware to do?
Arris TG2492 (VM Super hub 3)
|
14-06-2019, 12:37 AM
You have my interest, just what exactly do you want to modify this firmware to do?
14-06-2019, 02:03 AM
30-06-2019, 09:59 PM
(29-04-2019, 02:20 AM)blacklisted Wrote:(22-04-2019, 08:08 PM)emantec Wrote: Did you flash my entire dump to your modem? That contained device specific files which may explain your issues. you have flash the TG2492 ? through the emmc?
02-07-2019, 06:36 AM
15-07-2019, 03:14 PM
This is my full story if someone is interrested... https://blog.danman.eu/about-adding-a-st...sis-modem/
16-07-2019, 05:04 AM
(15-07-2019, 03:14 PM)danman Wrote: This is my full story if someone is interrested... https://blog.danman.eu/about-adding-a-st...sis-modem/ good. ill have to buy an oscilloscope.
16-07-2019, 06:43 AM
(16-07-2019, 05:04 AM)eltremendo Wrote:(15-07-2019, 03:14 PM)danman Wrote: This is my full story if someone is interrested... https://blog.danman.eu/about-adding-a-st...sis-modem/ If you have the same phison on board, the pinout is the same (this has been verified with several noards). But you can also use logic analyzer, they are cheaper...
17-07-2019, 01:30 AM
it is yes can confirm.
trhanks once again
07-08-2019, 10:18 PM
thanks for the great info, going to grab a new modem to test test test
08-08-2019, 09:56 AM
few people in uk should be able have access to these arris modems
|
« Next Oldest | Next Newest »
|