Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Help with sb5101E upstream ranging
#11
Ok i uploaded logs what u thing without coax i dnt know if this correct logs or not its my first time operating with this modem .


Attached Files
.txt   putty.txt (Size: 41.3 KB / Downloads: 25)
[Image: 3811042289.png]
Reply
#12
Your being told to go to a non-existant frequency, by your non-vol, goto frequency in haxorware, and input your local frequencies Wink

If not that, plug in coax lol..

Cause your cut off..
Reply
#13
Jesus is working lool i cant believe after i went home i just pluged in modem in power.. and worked i dont touched nothing i leave as las night while tried i thing it was problem with isp last night the neibour event logs was same as my modem.

Special thanks to haxorware forum members and rajkosto for firmware.

How to protect from being banned?

Can i uncapp this model 5101e?

Thanks
[Image: 3811042289.png]
Reply
#14
To deter eth banning:

In serial/telnet:

/non-vol/halif/eth_reject_cam 0
/non-vol/write both
Reset

As for un-capping, duno nowt about your node Sad
Reply
#15
(08-06-2015, 03:29 PM)Canis-Major Wrote: To deter eth banning:

In serial/telnet:

/non-vol/halif/eth_reject_cam 0
/non-vol/write both
Reset

As for un-capping, duno nowt about your node Sad

Thanks u . wht du u mean u dont know about node

Haxorware integrated telnet daemon

Username: root
Password: ****
Welcome.
CM>
CM> /non-vol/halif/eth_reject_cam 0

Ethernet reject CAM enabled: 0

NOTE: You must write the settings and reboot for the change to take effect!

CM> /non-vol/write both

Dynamic Non-Vol Settings successfully written to the device.
Permanent Non-Vol Settings successfully written to the device.

CM>
[Image: 3811042289.png]
Reply
#16
Only you can know what you can do on your wire (node)

And the reason for /write both is to save across reset's AND firmware update's Smile
Reply
#17
Thanks canis .. just let me know how to uncapp it and i will try it .
And what else should i do in modem ?
[Image: 3811042289.png]
Reply
#18
Save your downloaded config.. this the file you need to modify to uncap.. it can be downloaded in the haxorware overview page at bottom. See the plethora of post's on un-capping..
Reply
#19
(09-06-2015, 03:27 PM)Canis-Major Wrote: Save your downloaded config.. this the file you need to modify to uncap.. it can be downloaded in the haxorware overview page at bottom. See the plethora of post's on un-capping..


Thanks i will try it.. another question connection is not stable is droping to much. Whats problem any idea
[Image: 3811042289.png]
Reply
#20
All I can figure out rifght now is it's dropping too much lol, chance's are your isp is trying to kick you, or you have a mac too lose to you and both you and the 'donor' modem are fighting to stay on?
Reply


Forum Jump:


Users browsing this thread: 5 Guest(s)