pull config from sub?

[suckafree]

Or, just use your NT and pull the nonvol off of it.

Don't have a jtag Im waiting for my USB ttl should be here sat.

[southernyankey1970]

That works too, but you're gonna want a jtag. At least cough up 35.00 for a Blackcat USB. Don't think you can pull a nonvol with a ttl...

[drewmerc]

That works too, but you're gonna want a jtag. At least cough up 35.00 for a Blackcat USB. Don't think you can pull a nonvol with a ttl...

you can you just run a pre 1.1 version of hax from memory and dump the nonvol

[suckafree]

How do I dump the nonvol on my Cisco 2100 using the USB ttl cable?

[drewmerc]

Code:

Set your computers ip to 192.168.100.10
  Set up a TFTP server with haxorware.bin in its root (a pre 1.1 version)
  Connect to modem with hyperterminal or putty (with changed CR/LF to LF)
  While modem is turning on press p (you should get a prompt)
  If you do not get a prompt for pressing p, your modem does not have a noisy bootloader, and you will have to use JTAG
  Set the Modem IP to 192.168.100.1
  Leave everything else at their defaults (just press enter)
  When you get at the bootloader menu press g (i think, it says run from ram)
  Enter 192.168.100.10 as TFTP IP
  Enter haxorware.bin as filename

[suckafree]

Code:

Set your computers ip to 192.168.100.10
  Set up a TFTP server with haxorware.bin in its root (a pre 1.1 version)
  Connect to modem with hyperterminal or putty (with changed CR/LF to LF)
  While modem is turning on press p (you should get a prompt)
  If you do not get a prompt for pressing p, your modem does not have a noisy bootloader, and you will have to use JTAG
  Set the Modem IP to 192.168.100.1
  Leave everything else at their defaults (just press enter)
  When you get at the bootloader menu press g (i think, it says run from ram)
  Enter 192.168.100.10 as TFTP IP
  Enter haxorware.bin as filename

After connecting the usb is my modem only gonna have 1 light on?