Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
sb5101 goes in reboot cycle
#11
(18-11-2012, 04:28 AM)ABMJR Wrote: Good...

Unticked force network access and firmware upgrades, but still rebooting. Disabled T4-no rebooting, but not getting valid IP with or without force network access and firmware upgrades.
Reply
#12
u need to get non-vol to make it work. certs alone is not enough now
Reply
#13
It's also working fine in other places.

Thats the problem...

Get a new test setup. that one is on too many cmts' databases now.
Reply
#14
(20-11-2012, 12:59 AM)southernyankey1970 Wrote: It's also working fine in other places.

Thats the problem...

Get a new test setup. that one is on too many cmts' databases now.

You're right, new test setup solved the problem.
Reply
#15
so a valid nonvol can be used a couple times ?????
Reply
#16
(06-12-2012, 08:18 PM)digitalx1 Wrote: so a valid nonvol can be used a couple times ?????
as in flashed as many times as you want yes
but
more than one online at a time not always
Reply
#17
Depends entirely upon the ISP and how well they mind the store. Smaller ISP's can be very efficient at in house security. It mainly depends upon who is running security and how many features are enabled. There are so many variables that affect it that you can find holes where you would never think to look using method(s) that you would never believe until you saw it happen...My area has been fully upgraded for some time now, and different things work in different neighborhoods...you won't know for sure until you test to find out.
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)