Haxorware Forums › General › Modems v
Telenet Command To Clear NAT

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
Telenet Command To Clear NAT
GreekDad Offline
Haxorware Enthusiast
***
Posts: 27
Threads: 8
Joined: Apr 2012
Reputation: 0
#1
02-07-2015, 06:41 AM
Anyone know of a Telenet command I can use to clear the NAT table?
Find
Reply
neo_ Offline
/dev/null
*****
Posts: 510
Threads: 2
Joined: Nov 2013
Reputation: 15
#2
02-07-2015, 06:43 AM
DOCSIS does not have a NAT protocol.
Find
Reply
GreekDad Offline
Haxorware Enthusiast
***
Posts: 27
Threads: 8
Joined: Apr 2012
Reputation: 0
#3
02-07-2015, 06:53 AM
Haxorware has a NAT table inside of it that when it gets too full due to too many IP changes you must reboot the modem to clear this table. I want to clear this table without rebooting the modem.
Find
Reply
neo_ Offline
/dev/null
*****
Posts: 510
Threads: 2
Joined: Nov 2013
Reputation: 15
#4
02-07-2015, 07:57 AM (This post was last modified: 02-07-2015, 07:58 AM by neo_.)
(02-07-2015, 06:53 AM)GreekDad Wrote: Haxorware has a NAT table inside of it that when it gets too full due to too many IP changes you must reboot the modem to clear this table. I want to clear this table without rebooting the modem.

That is not a NAT table. It is called a routing table.

Stop using so many torrent seeds or get a modem with more memory.
Find
Reply
Canis-Major Offline
Banned
Posts: 386
Threads: 21
Joined: May 2015
#5
02-07-2015, 09:42 AM
Another downside to the so called new security, is that you cant change ip's as often as used to be possible, and I would go as far as to say, ip's are now like your postcode, your stuck with it, how else dya think they'll catch all those pirate's? You may be able to change last 4 digit's, but no more, this I can defo confirm is in effect here, same ip give or take a few digit's since 2010
Find
Reply


Forum Jump:


Users browsing this thread: 3 Guest(s)