Haxorware Forums › General › Modems v
set US channels value from the SSH

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
set US channels value from the SSH
kvant0x Offline
Haxorware Enthusiast
***
Posts: 83
Threads: 24
Joined: Sep 2010
Reputation: 0
#1
03-08-2014, 06:45 PM (This post was last modified: 03-08-2014, 07:09 PM by kvant0x.)
Is it possible to set US Channels value (US=1) from the SSH shell?
forceWare v1.1r12
Find
Reply
sixteen Offline
Haxorware Expert
*****
Posts: 392
Threads: 34
Joined: Apr 2012
Reputation: 6
#2
04-08-2014, 05:51 AM
What is rong with your upstream?
Find
Reply
kvant0x Offline
Haxorware Enthusiast
***
Posts: 83
Threads: 24
Joined: Sep 2010
Reputation: 0
#3
04-08-2014, 08:25 PM (This post was last modified: 04-08-2014, 08:26 PM by kvant0x.)
(04-08-2014, 05:51 AM)sixteen Wrote: What is rong with your upstream?

by default Fw initializes parameters: -ds_channels 4 -us_channels 4
I noticed that only 1 upstream channel is used when ready. But for some reason I can't get US_channels working at all.
Find
Reply
coldfusion Offline
Forever Reading - Always Learning
****
Posts: 103
Threads: 9
Joined: Jan 2011
Reputation: 4
#4
04-08-2014, 10:18 PM
I had the same issue on 1.1r12, I reverted to 1.1r11 and locked on okay, it's strange, I am seeing different reports about signal/locking issues from different people.
Find
Reply
sixteen Offline
Haxorware Expert
*****
Posts: 392
Threads: 34
Joined: Apr 2012
Reputation: 6
#5
04-08-2014, 10:37 PM (This post was last modified: 04-08-2014, 10:41 PM by sixteen.)
Need to check your RF plant or make a service call.
Find
Reply
kvant0x Offline
Haxorware Enthusiast
***
Posts: 83
Threads: 24
Joined: Sep 2010
Reputation: 0
#6
06-08-2014, 09:29 PM
my ISPs only support 1 channel upstream bonding.
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)