+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: Haxorware 1.1 vs infinite (/showthread.php?tid=633)
Haxorware 1.1 vs infinite - paziulek - 10-10-2010
I started with the coax mods about 4.5-5y ago... with sigma 1.x, 4200/4100 and 5100/5101 later. 3-4 years ago it became more important to run on Docsis2, sigmax had problems.... it sucked, finally SB5100MOD by tplewa worked for me best ( still using it ). for 5101 infinite f/w based on sigmax also was doing a good job, without much hassle, no reboots on torrents or usenet... Haxorware 1.1 rev XX ( whatever was "current" 2 years ago ) gave me some trouble, it did not stay for too long in the flash...
I am on RR, dynamic configs, TWC replaced all or most 1 & 1.1 in the area, plus, the UL/DL speeds used to be way lower on 1.x f/w...
I would like to know how HaxorWare is now compared to 2y ago? I like the interface, but performance results were not top of the line... I cannot find info what docsis it likes - is it 1.0, 1.1 or 2.0? ( I doubt that it was 2.0 2y ago when I was testing it )
Thanks a lot!
ps: sb5100mod last reboot - around 1TB transferred in the meantime ( usenet rocks - torrent sucks ):
Code:
2010-04-03 00:24:57 7-Information 0x848E0004 I500.0 Registration CompletedRE: Haxorware 1.1 vs infinite - drewmerc - 10-10-2010
since you last tested haxor the biggest change will be the fact there are 2 versions, just for the reasons you mentioned (diag and lite)
diag includes diagnostic output and console but might not perform optimally on a 8mb ram modem. lite does not support spi flash based modems but has less ram usage
personal experience with haxor and usenet is i have never had any sort of problem (using diag with 8mb ram), 20 connections and never had any slowdown or crashes even when using a 50mb config (getting about 35mb down but this was due to a modem limitation before the isp blocked the config)
RE: Haxorware 1.1 vs infinite - paziulek - 10-10-2010
Thank you for your response drewmerc, with low simultaneous connections even sigma 13x-14x was quite stable, dc++ or torrent sigma was dead after a few minutes with 2000+ max connections on the client. Is Haxorware 1.1 Docsis2.0 or 1.x?
you said "lite" does not support spi based modems... do you mean max232+tftp or dhcp_force update method modems? like the popular rca/thomson or arris boxes?
and 35Mbit down is still good - around 42 is the channel max for docsis ( unless you're located in EuDocsis area ) - are you running docsis 1.x or 2.0 on your Haxor 1.1?
This is quite some time, but as far I remember sb5100mod by tplewa generates the certs, so it is not required to preserve the original one... am I right?
Thanks!
- 4am, got to take a nap..
RE: Haxorware 1.1 vs infinite - drewmerc - 10-10-2010
docsis2 with legitimate certs depending on your isp haxor can fake sign certs
spi is a type of flash chip(over simplification) , sb5101 is tsop48 flash based and an ambit256 is spi
(never seen a rca or arris modem as i am eurodocsis)
RE: Haxorware 1.1 vs infinite - chris305 - 24-09-2011
Haxorware beats infinite.