+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Off topic (http://www.haxorware.com/forums/forumdisplay.php?fid=8)
+--- Thread: Cisco DTA 271HD (/showthread.php?tid=4138)
Cisco DTA 271HD - geoneo111 - 26-07-2016
I want to read the log on this device with a USB to TTL adapter. I'm hooked up as follows:
USB TTL SPI Winbond
Receive => Pin 2 (SO)
Transmit => Pin 5 (SI)
Ground => Pin 4 (GND)
Putty config:
Baud rate 115200
8 none 1
Flow control set to NONE
I'm just getting garbage though.
Can I even read this? I should, right? Just want to see how it boots up.