+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: SB5100i Debrick help (/showthread.php?tid=3864)
SB5100i Debrick help - sunny13_8 - 19-01-2016
I have flashed my sb5100 with haxorware is now bricked. I have PJTAG, when trying to flash a backup firmware using ldram 9fc00000 , tom's jtag utility is showing error "Address out of range"
Here is the whole console output
Read IDCODE: 0x0334817f
Manufacturer: Broadcom
Part: BCM3348
Version: 0x0??? (BCM3348KPB)
---------------------------------
Create & Clear RAM Buffer (0x80000000 - 0x80800000)
Load Configuration File: bcm3348.def
IR Length: 0x5
Endian: Big
Protocol: EJTAG
RAM Start Address: 0x80000000
RAM Size: 0x800000
FLASH Start Address: 0x9fc00000
---------------------------------
Read IMPCODE: 0x00800908
EJTAG Version: 1 or 2.0
EJTAG DMA Support: Yes
---------------------------------
Detect FLASH : Unknown (Manufacturer’s: 0x0000 Device: 0x0000)
jtag> ldram 9fc00000
Address out of range
I have tried the 3.3v method, but no avail. I'm using a BIOS button cell for the 3.3v source. I'm not sure if i'm touching the right pin number of the chip ?
Please someone help, it's my first time that i'm stuck with this type of problem.