+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: Need 8x4 firmware for dpc/epc3010 (/showthread.php?tid=3615)
Need 8x4 firmware for dpc/epc3010 - christianrodher - 14-06-2015
anyone have a firmware that connects with the 8 channels?
RE: Need 8x4 firmware for dpc/epc3010 - Rudde - 30-04-2018
I know I am quite late to the party, and I don't even have DSL internet anymore, however I have two of these laying around and got back in here to do what I can with them. I would like to try to do something and break them insted of just throwing them out.
I have taken them a part, but I'm not sure how I would go about extracting the firmware?
RE: Need 8x4 firmware for dpc/epc3010 - occalifornia - 01-05-2018
(14-06-2015, 10:36 PM)christianrodher Wrote: anyone have a firmware that connects with the 8 channels?
like forceware, or stock?
RE: Need 8x4 firmware for dpc/epc3010 - demonspride - 01-05-2018
if anyone still needs, here is a few, i dont know which is which, i know one has an unshadowed NV. as always, youre welcome, and keep on testing.
https://mega.nz/#!uJ1VAJgB!nheZSDu65p0DPdd9hU7nvttmwGAKzG_TXReMlRJvbNU
RE: Need 8x4 firmware for dpc/epc3010 - Wichin12 - 01-05-2018
(01-05-2018, 07:41 AM)occalifornia Wrote:Forceware doesn't work on the 3010 cuz it's Broadcomm(14-06-2015, 10:36 PM)christianrodher Wrote: anyone have a firmware that connects with the 8 channels?
like forceware, or stock?
RE: Need 8x4 firmware for dpc/epc3010 - ricktendo - 02-05-2018
I think the reason he wanted this firmware is because it appears you can force config using this stock firmware
RE: Need 8x4 firmware for dpc/epc3010 - demonspride - 04-05-2018
yes you can, in fact, most BCM modems to this date support fake_reg and Force_config, including 6183 and CM8200.
RE: Need 8x4 firmware for dpc/epc3010 - bustah - 04-05-2018
force config + dhcp_settings never worked using local tftp.
RE: Need 8x4 firmware for dpc/epc3010 - 0xff - 05-05-2018
(04-05-2018, 05:28 PM)demonspride Wrote: yes you can, in fact, most BCM modems to this date support fake_reg and Force_config, including 6183 and CM8200.
Force_config is not tftpenforce bypass, true?
RE: Need 8x4 firmware for dpc/epc3010 - shanontoro - 14-11-2018
Ola como estas soy chano yo tengo un modem 6183 y1602 los dos son arris si se podran echar andar