SBG6580 twerking help - Printable Version +- Haxorware Forums (http://www.haxorware.com/forums) +-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6) +--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7) +--- Thread: SBG6580 twerking help (/showthread.php?tid=3455)

SBG6580 twerking help - deadsled - 11-03-2015 Hi all, I am a newbie to this forum but not to werld of console, phone, misc electronic tweaking and twerking. My question is what do I need to gain access to my modem for modifying? Is jtag the only way or can gain access via ethernet connection/network. I have done some searching but my ADD has me going in circles trying to make sense of it! A tutorial would be awesome if someone could please point me in that direction. Short story is I want to change my docsis 2.0 modem to a docsis 3.0 and I need to change it's mac. thanks RE: SBG6580 twerking help - neo_ - 11-03-2015 Wait, you are interesting in twerking your modem? RE: SBG6580 twerking help - deadsled - 11-03-2015 Yes, I want to make it shake and wiggle! I have some old pic development boards...can I use these to read/write like the usbjtabnt? http://www.pic16.com/en/wzcapi/m07.htm It looks like I can, it has a usb and rs232/serial interface. I can jumper the wires or just remove the chip all together if need be RE: SBG6580 twerking help - neo_ - 11-03-2015 No, just buy a USB JTAG NT if you want the easiest/best solution. A blackcat USB for cheaper solution. Or build your own parallel JTAG for the cheapest solution. Depending on the modem, some have a serial rx/tx connector which you can use to initiate a firmware flash. RE: SBG6580 twerking help - deadsled - 11-03-2015 Unfortunately money is a concern, however, I have parallel cables and a computer to use them with. Here is my board, it's a Motorola sbg6580 Can anyone point me towards a tutorial on the parallel cable technique? thanks RE: SBG6580 twerking help - drewmerc - 11-03-2015 http://www.haxorware.com/forums/showthread.php?tid=3409