+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: how to do a full flush on ambit via serial. (/showthread.php?tid=2380)
how to do a full flush on ambit via serial. - jatrick2001 - 01-03-2013
Hello everyone.I successfully installed haxorware on one of my ambit but something went wrong.I been trying to figure out is it possible to do a full flash via serial using putty.I did try to press w(write) but then i get stuck on the hex address and the hex value.Does anybody knows those numbers or is it even possible.
RE: how to do a full flush on ambit via serial. - drewmerc - 01-03-2013
if it's a full flash it's 0
RE: how to do a full flush on ambit via serial. - jatrick2001 - 02-03-2013
Thanks a lot man but it did not work.It crashed, I guess i did something wrong .but I will find out how to do a 2MB flash.
RE: how to do a full flush on ambit via serial. - southernyankey1970 - 02-03-2013
JTAG....
RE: how to do a full flush on ambit via serial. - southernyankey1970 - 02-03-2013
I know there is a way to do it serial but i found that it is just soooo much easier with a jtag. I struggled for months with that shit before i could afford to creak open my wallet and buy the proper toys. It takes longer to load the damn bin on my NT than it does to reflash a modem. Best 70 bucks i ever spent on this ridiculous hobby!!!!