newbie help please guys !! - Printable Version +- Haxorware Forums (http://www.haxorware.com/forums) +-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6) +--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7) +--- Thread: newbie help please guys !! (/showthread.php?tid=206) |
newbie help please guys !! - tweenage - 04-06-2009 hi am new to this forum and am having a few problems trying to set it up ,have tried everything i have read and still failing to get a connection and was hoping someone would be kind enuf to help me out of my prediacment , i have haxoware 1.1 rev 31 installed on my sb5101e modem now i get confused in overview i have this Task Status Acquire Downstream Channel Done Obtain Upstream Parameters Done Upstream Ranging Done Establish IP Connectivity In Progress Retrieve Time of Day Waiting Negotiate security Waiting Receive configuration Waiting Register connection Waiting Cable modem status Ranging Complete signal i have this Downstream Frequency 331 MHz Status Locked Annex DOCSIS Modulation QAM256 Symbol Rate 5360537 sym/sec Receive Power 3.7 dBmV Signal to Noise ratio 39.0 dB Upstream Frequency 34 MHz Channel ID 3 Status Ready Mode TDMA Symbol Rate 2560000 sym/sec Transmit Power 40.0 dBmV i have tried to use dhcp sniffer , but not sure if i have to have the modem actually connected to the net before i use it? cos when i try to sniff i just get no bootloader macs found it says region NONVOL an d the only files i have are CM0014E8AC96B2.tar and nonvol.bin (32768 bytes) my settings are such General Factory Mode Disable Firmware Upgrades / Force Network Access / Tftp Enforce Bypass Ignore Unknown Messages / Disable IP Filters on startup Administration Control Panel IP Address 192.168.100.1 DHCP Server / WebGUI Password protection Username root Password ***** Telnet Server Current state Running Run on startup / Username root password ***** frequencys are Annex docsis Plan european Preferred DS Freq 1 331000000Hz Preferred DS Freq 2 339000000Hz Preferred DS Freq 3 330750000Hz Upstream Channel 0 Addresses HFC MAC 00:14:E8:AC:965 Ethernet MAC 00:14:E8:AC:96:B3 USB MAC 00:14:E8:AC:96:B3 Serial Number 140255606729998301021001 Certificate generation Certificate type mtorola docsis config file reads liek this Force Config File Server IP File name cm-2148-256 Autoserve Autoserve Config File (disabled) Store new config sorry for the long winding lots of extars thread , but its better to put everything down in the hope that sum1 can tell me what im doing wrong , as i keep having to drive around looking for hotspots to try and read what im doing wrong , but its very hard to do so , then run back home to try and read and also do , what i had previosuly read many thanks in advance for any help tween or maybe there is a file i can upload and solve all my problems also i see that there are 3 mac addresses hfc ,ethernet , and usb mac what are all these for? RE: newbie help please guys !! - rajkosto - 06-06-2009 you need to either use static ip and autoserve a config file, or clone someones hfc mac RE: newbie help please guys !! - badger - 07-06-2009 untick force network access and take out cm-2148-256 . Also I have found if you put HFC Mac address in, then ehternet mac is HFC + 6 in hex, and usb is -1. Serial number is HFC mac without the : in. It also helps to spoof your ethernet mac. |