+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: dcc arrive new sb5100 issues (/showthread.php?tid=1993)
dcc arrive new sb5100 issues - wildacex187 - 25-09-2012
hello guys, newbie here
seems that my sb5100 has been having connectivity issues as of late. in the logs i have see that i tend to lose connectivity when the instance "dcc arrive new" shows up. i searched the forum and it seems that this guy here had a similar issue but i dont think he resolved it.
while searching google i came across disabling bpi through telnet but that just rendered my modem useless and had to enable it back to get connectivity. should i try disabling bpi+?
my isp is TWC and im in nyc.
thank you for your help.
RE: dcc arrive new sb5100 issues - BornDirty - 25-09-2012
You may need to upload certs to the modem. If your using a old firmware such as Sigma its not going to happen you may use a stock dump and modify it.
(25-09-2012, 08:38 AM)wildacex187 Wrote: hello guys, newbie here
seems that my sb5100 has been having connectivity issues as of late. in the logs i have see that i tend to lose connectivity when the instance "dcc arrive new" shows up. i searched the forum and it seems that this guy here had a similar issue but i dont think he resolved it.
while searching google i came across disabling bpi through telnet but that just rendered my modem useless and had to enable it back to get connectivity. should i try disabling bpi+?
my isp is TWC and im in nyc.
thank you for your help.
RE: dcc arrive new sb5100 issues - wildacex187 - 26-09-2012
(26-09-2012, 05:35 AM)dragonlord7791 Wrote: what you need to do is using sb5101 whith haxorware,or one original firmware in the sb5100
i got this issue for long time,and the only fix it was that i tell you above
it work s for me
not sure i quite understand what you said here.
RE: dcc arrive new sb5100 issues - haroldstein - 26-09-2012
(26-09-2012, 05:45 AM)wildacex187 Wrote:Did you make an original back up of your 5100?(26-09-2012, 05:35 AM)dragonlord7791 Wrote: what you need to do is using sb5101 whith haxorware,or one original firmware in the sb5100
i got this issue for long time,and the only fix it was that i tell you above
it work s for me
not sure i quite understand what you said here.
If so, then reflash you modem, and start over.
what are you using, Blackcat, usbjtagnt?
RE: dcc arrive new sb5100 issues - ABMJR - 26-09-2012
DCC is mandated by the CMTS...
DCC=Dynamic Channel Change. Done after registration
Usually to move a D2 or lower CM to a "pool" of channels for them...thus staying away from the D3 channels and the bonding..Allows the D3 tier to have the most B/W (on-demand) and is isolated from the majority of CM's (D2's and lower)