SBV6220 i cant detect - Printable Version +- Haxorware Forums (http://www.haxorware.com/forums) +-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6) +--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7) +--- Thread: SBV6220 i cant detect (/showthread.php?tid=1592)

SBV6220 i cant detect - sixteen - 19-05-2012 I have my connection right, my problem is how do i apply the 5volt to the chip because it seams the 3.3volt is too low. Should i solder a external 5volt power to where the 3.3v is connected to the modem? RE: SBV6220 i cant detect - drewmerc - 19-05-2012 if memory serves (it does not always) you connect 5v to the vcc of the chip not the entire modem i did this just using a cut usb cable to replace the vcc wire RE: SBV6220 i cant detect - sixteen - 19-05-2012 Let see if i get you before i try it. unsolder the 3.3v and GND form the SPI chip on the modem board and replace it with the 5v and GND from the USB cable wire right?