+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: A working sb5100 (/showthread.php?tid=1303)
A working sb5100 - splifey - 15-01-2012
I have a working sb5100 i want to exchange with another 5100 that i have because of some physical problems (What do you guys recommend at the time i have a pjtag )
if i get some certs( can i keep using them in different modems and nodes?)
RE: A working sb5100 - drewmerc - 16-01-2012
1.just do a full dump and flash it to the other modem
2.no (it will be detected)
RE: A working sb5100 - splifey - 16-01-2012
(16-01-2012, 12:06 AM)drewmerc Wrote: 1.just do a full dump and flash it to the other modemhow would i go about doing that. Blackcat Read all save, Then switch, write all ?
2.no (it will be detected)
One more thing. i was searching around.. does a full 2meg dump wrk no cer and work at the said speed? ( with the /premade)
RE: A working sb5100 - drewmerc - 16-01-2012
1.yes
2.wat
RE: A working sb5100 - splifey - 16-01-2012
(16-01-2012, 01:20 AM)drewmerc Wrote: 1.yes
2.wat
Does a premade 2meg dump file mean it'll work at 2megs speeds with no certs?
RE: A working sb5100 - drewmerc - 16-01-2012
lol no
2mb is the filesize of the dump not the speed rating
and yes you'll need certs from now on
(thats also the reply to your PM as i cant reply if you dont have them enabled)
RE: A working sb5100 - splifey - 16-01-2012
(16-01-2012, 01:49 AM)drewmerc Wrote: lol no
2mb is the filesize of the dump not the speed rating
and yes you'll need certs from now on
(thats also the reply to your PM as i cant reply if you dont have them enabled)
Gotcha, I have come to another complication . Im out of solder ( I want to extract certs from the ogirinal working sb5100 and put them in another along with the mac )Im thinking full ip but where should i start ? Pms enabled Thanks
RE: A working sb5100 - drewmerc - 16-01-2012
ip full should do it fine