super 2 ac / vmdg 490 - Printable Version +- Haxorware Forums (http://www.haxorware.com/forums) +-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6) +--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7) +--- Thread: super 2 ac / vmdg 490 (/showthread.php?tid=3582) |
RE: super 2 ac / vmdg 490 - andy m - 12-06-2015 if a setup teaviewer is it possible you can have a look on my end if i connect the 485 to serial RE: super 2 ac / vmdg 490 - Canis-Major - 12-06-2015 I dont use teamviewer dude, would prefer to wait till I get my hands on a box, should'nt be too long.. I did however have a quick look at your dumps, and it would appear there are actually 3 ubfi's, the third being ubfi3, which is ram reserved, possibly explaining why when you attempt mac change, it revert's back, suggesting that the box has a hardcoded image, and if you change any the 1st 2, and it dont match the third, it'll reverse.. This of course, could be complete bollox.. RE: super 2 ac / vmdg 490 - andy m - 13-06-2015 is anyway to enable telnet using serial space br option RE: super 2 ac / vmdg 490 - Canis-Major - 14-06-2015 Yes, answers are on either cw or foro, under the guise of, which was the command to block incoming/outgoing, as in 0x40, or was it 0x@ with regard's to what is allolwed to pass whatever port, be it serial, com, eth, or COAX. Find it in the flash, hexedit serial/telnet like they used to, enable whatever, just for access Fuck it: SNMP CM online Para tener acceso online tendreis ke activar el interface ethernet Valores acceso interfaces À= ambos cable y ethernet / hex 0xc0 @= cable / hex 0x40 €= ethernet /hex 0x80 /teclado AltGr + e Desde consola solo se puede poner string no hexstring, copiar Y pegar desde Consola serial, telnet, SSH Para ambos interface: cd / cd s set docsDevNmAccessInterfaces.10 string À y set docsDevNmAccessIpMask.10 ip 0.0.0.0 y para solo ethernet: (recomendado) cd / cd s set docsDevNmAccessInterfaces.10 string € y set docsDevNmAccessIpMask.10 ip 0.0.0.0 y Go figure Ps: This: À will not appear as in telnet, this is why you fail. |