+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: Flashcat USB Status : disconnected? (/showthread.php?tid=3476)
Pages:
1
2
RE: Flashcat USB Status : disconnected? - newname - 06-10-2019
Hang on a sec.....once drew finishes his tea and crumpets....he will give you a few more tips.....unless of course he has a cricket match to go to.
RE: Flashcat USB Status : disconnected? - Andrew956 - 06-10-2019
Is there any settings I would have to put windows 7 and FC classic
RE: Flashcat USB Status : disconnected? - Andrew956 - 06-10-2019
(06-10-2019, 01:20 PM)newname Wrote: Hang on a sec.....once drew finishes his tea and crumpets....he will give you a few more tips.....unless of course he has a cricket match to go to.Sounds like the rapper 21 Savage
RE: Flashcat USB Status : disconnected? - Andrew956 - 06-10-2019
(24-03-2015, 07:05 AM)drewmerc Wrote: hit the reset button
Help me Out Drew I haven’t slept pleaseeee
RE: Flashcat USB Status : disconnected? - drewmerc - 06-10-2019
hold the reset button and then plug it in, if that fails flip the switches and try again
RE: Flashcat USB Status : disconnected? - Andrew956 - 06-10-2019
I tried it an switched the switches every way and it still blinks do I need a tftp set up
RE: Flashcat USB Status : disconnected? - drewmerc - 06-10-2019
what are you trying to do?
RE: Flashcat USB Status : disconnected? - Andrew956 - 06-10-2019
Just make my fc visible.. do I have to flash it with boot utility? I’m stuck
RE: Flashcat USB Status : disconnected? - arrobazo - 07-10-2019
let me see if I understand @Andrew956 ...
Do you have your FCUSB with problems to recognize?
You can do the following:
° lower the switch in bootloader mode, there you have an example
![[Image: 0953d4065f5c1ef9ab603b7d421914a1.png]](https://i.gyazo.com/0953d4065f5c1ef9ab603b7d421914a1.png)
° press the bootloader button with the fcusb obviously connected, no matter if the software is not open.
° open any version of the Flashcatusb software [compatible with the pcb version of fcusb classic]
° click AVR Firmware and Load File
° select fw FCUSB.CLASSIC.x.xx.PCBx.x.hex compatible with your version of Flascatusb classic.
° click Program
° after it is programmed, click on Start Application