+- Haxorware Forums (http://www.haxorware.com/forums)
+-- Forum: General (http://www.haxorware.com/forums/forumdisplay.php?fid=6)
+--- Forum: Modems (http://www.haxorware.com/forums/forumdisplay.php?fid=7)
+--- Thread: Recommended tools for flashing on DCM425 (/showthread.php?tid=1987)
Pages:
1
2
RE: Recommended tools for flashing on DCM425 - drewmerc - 30-09-2012
![[Image: 9jJHm.jpg]](http://i.imgur.com/9jJHm.jpg)
RE: Recommended tools for flashing on DCM425 - ZeeLex - 30-09-2012
OK, the following steps i did to flash
1. I connected wires as followed
RX to RXD, TX to TXD, GND to GND and VCC to 5.0V ( or should I connect VCC to 3.3V)
2. Connected USB (Message, Cable Activity, Cable Link and PC Link lights are on)
3. Connected AC adapter ( when i connected AC Adapter only Internet light is flashing)
4. Connected ethernet cable
and here is the video for next steps
http://www.youtube.com/embed/5-ceHnmV76g
When i open the Putty nothing is heppening
RE: Recommended tools for flashing on DCM425 - drewmerc - 01-10-2012
vcc is 3.3
to hung over to watch a video
RE: Recommended tools for flashing on DCM425 - chrispy9658 - 23-08-2014
I hate to gravedig this thread, but im having the same issue as the guy above had.
My putty terminal is empty. I have the exact settings that he has. Not sure what I could be doing wrong?
RE: Recommended tools for flashing on DCM425 - chrispy9658 - 06-09-2014
BUMP. I just tried with another usb to ttl cable, and still, empty putty terminal. I have this cable wireout
red power, black ground, white RX into USB port, and green TX
So I have them i the order of red-black-green-white as from this picture: http://i.imgur.com/9jJHm.jpg
Can anyone please explain what I'm doing wrong? I have my putty set at COM5 (which is correct, found via devmgr) and speed is 115200
RE: Recommended tools for flashing on DCM425 - drewmerc - 06-09-2014
try different speeds and see if you get garbled output, also you could try crashing the bootloader
in the end you may just have an updated silenced bootloader
RE: Recommended tools for flashing on DCM425 - chrispy9658 - 06-09-2014
Even under lowered speeds, I still have no output.
I just did a quick search, and I can't find a way to downgrade the bootloader :/
I was hoping for a weekend project. Shucks.
RE: Recommended tools for flashing on DCM425 - scorp8669 - 21-12-2019
Can someone assist to what pins I need to connect the TCM425 on the 10 pin JTAG (LPT)?
And, what is the recommended software
Thanks
RE: Recommended tools for flashing on DCM425 - occalifornia - 21-12-2019
(21-12-2019, 10:47 AM)scorp8669 Wrote: Can someone assist to what pins I need to connect the TCM425 on the 10 pin JTAG (LPT)?
And, what is the recommended software
Thanks
You've been a member for over a year and didn't start a thread for a new topic? come on man!
